Armor_Buff Regular

Very smart of Meng’s part.

If I hadn’t purchased a Meng Merkava IV w/Trophy & aftermarket PE for this a few months ago, I’d definitely buy this new kit.

A+++ for Meng

1 reply

Dan

I wish they would sell the cage separately.

2 replies

vettejack

Already have the aftermarket cage…pass.

Petition2God Supporter

Or get the cage 3D printed, Dan.

1 reply

CAC

Aftermarket is already available… I have two in my stash.

1 reply

Armor_Buff Regular

Hi @CAC Carlos, welcome to the forum.

FWIW
I purchased the Lanmo aftermarket item you mentioned. Several of the more knowledge members of IDF armor pointed out the way it attached to the Merkava isn’t accurate. I’m OK with that since I already have the item, just wanted to share a heads up if you haven’t purchased it.

1 reply

Dan

Do you make one James? I’ve seen the PE set and am not a fan of these large pieces.

1 reply

Petition2God Supporter

I’ll PM you later. I also want to give you an update on M3 stuff.

CAC

Buff,

I did notice that they attachment area needs some work to make it accurate (should not be too difficult to make something that looks good), but definitely good that you mentioned this so that others are aware.

alves

I have the same “problem”.

gtdeath13 Supporter

They could have at least made it Mk.4 400 with the optical sensors on the Trophy. Unless they add them on the kit during production

Franck_Lazare

Tetra Modelworks will launch the cope cage in photoetched part