G6 Rhino midway done!

Well, this is a lot more complicated than I had imagined.

Since I normally only build 1/72 or 1/76 armour, I thought it would be fun to take a run at a larger kit, and since I love the G6 Rhino SP gun, it seemed a natural target for my endeavours.

However, I will admit that I thought even though it was bit that building the Rhino would not be all that complicated. Sure, it had a lot more parts than I thought it would, but I was hoping a lot of them would be able to be bolted on at the end.

Joke’s on me!

Check out my progress on the Takom 1/35 Rhino at the link below. I am getting somewhere, but it’s sure a lot more work than I originally thought it would be!

The kit is not bad but a bit tricky in some spots. I built one and shared my experience here at Armorama. It could be of some help if you have not finished it yet.


The holes in the engine bay area are for the engine exhaust, you will need to fit something to areas, not looked at your build yet.