Righto I’ve done the above and added a few ‘improvements’ to the kit. Instead of spending another £20 on the eduard set I’ve done what I can myself,the results are,
Headlight guards cut out and card put in,they do clean up!
Water jets cut and new vanes in,
New engine cooling grill
Lots of cutting and plastic card but it’s ‘fun’
6 Likes
The mods with I bit of primer on,
Jacko
8 Likes
That’s pretty much all that was done to the hull,the suspension Airfix have actually got spot on so no need to mess around with that! Onto the load bed bulkhead for some obscure reason the lift handles have been moulded onto it and the rest of the handles are separate parts
sooo
Out with the saw and as you can see a tad to much came off
more card needed,
New handles made,
The other four were much too thick so I sanded them down to a better size,that is a general criticism of this kit some parts are way to thick!
Jacko
6 Likes
Just a bit of work done in the cab,
Kit BV out
New one from AA in,
Heating pipe running along the side of the cab,and the steering levers for the water jets removed.
Jacko
5 Likes
Ok some surgery done to the cab itself,
Cab roof with the kit grills and then removed to make way for the SMM grills and crane controls.
Kit fuel pipe cut off and a new one put in.
Jacko
4 Likes
Nicely done mate …. good job with those scratched areas.