Australian M113A1 1/16 scratchprint

I’ve been designing an Australian M113A1 with T50 turret in Fusion360, with a view to 3D printing it in 1/16.

Previously, I attempted to convert a very basic styrene flat pack kit.

After learning CAD during the pandemic, I started with a clean sheet.

Design started in April this year.

Then went to printing, assembly, & initial painting.


Thanks for looking in.

28 Likes

Looks fantastic!

1 Like

good luck with the 3D printing mate!

1 Like

If you want, I did some Australian radios for Mouse House Enterprises. I can send you a set if you intend on making an interior.

1 Like

Thanks mate, this is 1:16 scale. No interior, thankfully!

Was there ever a finished model to this epic tale? Since the Takom/Andy’s Hobbies kit just came out, I bet there is a LOT of interest in this again…

3 Likes