This review covers the second iteration of the fir tree, a 200mm tall single-piece 3D printed coniferous tree from RT Diorama.
This is partial text from the full article (usually with photos) at https://armorama.com/news/fir-tree-no2
This is partial text from the full article (usually with photos) at https://armorama.com/news/fir-tree-no2
4 Likes
This fir tree looks mighty impressive at 200mm tall and the photo of the 1/35 figure next to it adds scale. It will also work for 1/24 fantasy and Post-Apocalyptic figures in 1/35 and 1/24 scale.
It really is quite impressive, but as you said, painting it might be tricky, especially getting to that trunk all the way in there. You might need a thin dowel or styrene rod dipped in paint to do it.
For double the price and height compared to your 100mm fir tree review, I really like the 200mm tree better.
@Maki Do you have any other figure scales, such as 1/24 (75mm) to compare it to the 1/35 scale fir tree to see if the tree is too skinny for larger scales?
2 Likes
Sorry, I don’t have any 75mm figures in my stash. But I would think the scale difference would show between the 1/35 scale tree and 1/24 scale figure.
Mario
2 Likes
But I would think the scale difference would show between the 1/35 scale tree and 1/24 scale figure.
You’re most likely correct…
1 Like