As a bif fan of the Sd.Kfz. 222 I’ve had this one coming for some time now… It started many years ago when I looked inside the box of Tamiya’s kit - was very impressed, but I didn’t buy it then… Then there were the TV series “Allo Allo” - for the ones in the know - and then, much later First to Fight issued a 1:72 kit which I have bought right away. I started tinkering with it, but some details bothered me, so I started looking for PE to fix it and came to the conclusion, that the cheapest way to get it would be to buy ICMs kit (they wouldn’t sell me individual sprues). I ended up deciding on a kitbash of the F2F and ICM kits.
Let me post a couple of photos for a good start:
My goal is to build the 222 as it appeared in September '39. For that the ICM kit shows a vehicle that is too late. So I transplanted some of the F2F parts on the ICM kit - liek the lower suspension parts or that large storage box on the side of the vehicle, I also added some copper wire parts, as I like to do, and omitted the notek lights and made width indicators with white glue balls on their ends.
By the way - if anybody would like to share their 1:72 builds of vehicles of this family, they are more than welcome - we can have an informal group build, if you like.
For now - thanks a lot for your attention and have a nice day!
The model is tiny, so the construction is relatively speedy. I have put everything together, spending some time to detail the insides the turret a little - unfortunately that’s very hard to photogtaph.
Then I installed the ICMs PE and started painting - first I have painted the chassis dirt colour:
Then I put on some Panzergrau on top - I used the Hataka orange line paint. Plus some pigments and black wash:
I still have the fire extinguisher and the jack to install, maybe some stowage
@Robi - thanks a lot for your comment! I hope I can show you some of them babies…
It took me a log time, but I have finally installed the jack and did a little more weathering - and now the 222 is done:
Here I tried to photograph the insides of the turret - pretty hard to do. At least I know there’s something there - something better than both the F2F and the ICM offering:
The remainig photos of the 222:
And now I started two more: Sd. Kfz. 221 from F2F:
I have closed up the gaps in the floor and I have fabricated the rear wall with the radioator. Let’s see how much of this will be visible - probably not much.
It’s even more hopeless with the Sd. Kfz. 223 - here I “transplanted” sides from my unused F2F 222 hull:
As you can see there is already an opening in the roof where the PE mesh will go.
Let’s see where I can get from here - thanks for looking and have a nice day
I keep on working on the 221 and on the 223. As they both have the “small” turret, the interior has a small chance of being visible - so I’m working on the details supplied by F2F:
221:
Some of that might be visible through the mesh behind the turret:
223:
As in case of the 221 I have modified the MG base, so that the motorcycle seat it has is slightly offset to the left, like it should be. Additionally I have scratchbuilt a part that is supposed to represent the radio set as viewed from the rear:
Additionally I have designed and had them 3D printed for me the lower rocker arms of the early version (Horch 801 EG I):