Mike's MS Productions Review | Armorama™

Here we take a look a wide variety of Mike's products. First I will look at his SINCGARS Set, AN/VIC-3 Intercom System, and Heavy Vehicle Tow Pintle set.

This is partial text from the full article (usually with photos) at https://armorama.com/news/mike-s-ms-productions-review
1 Like

The radio sets look good.
However, I am obviously nitpicking here but the tow pintles look off to me. The issues may not be noticeable until you magnify like x3 in 1/35 but here’s what I see:

Problem areas circled in red:

Reference photos with those areas circled:

Top view:

  1. The top cut should be more angled (more like 45 degrees rather than 90 degrees) and extended.
  2. The inner semicircular half should have a lofted cut near the hole inside instead of being flat.
  3. The cut at the bottom is too high - should not be almost 1/2 circular. Should look more 1/4 circular.

Here’s my attempt to replicate the real thing as a comparison:

Those 3 areas can be seen differently on the prints:

Kind regards,