Today I was working on the Turret , I’ll try to explane how it’s supose to go together.
#1 in the insrtuctions section 30 part #F7 needs first to be inserted into the Turret top part # E7 with the small tab ( not shown in instructions on the side where the long hump beside the hatch is located
#2 Install the 2 parts C11 one on each side , they will go up to the bands on the shaft.
#3 Install the shaft cover part # D71 as shown so the tab on the shaft F7 innes up.
#4 The tab is meant to limit the amount the guns can be raised and lowered.
Care needs to be taken when adding the 2 small parts to the cover , for the slots for them go all the way through the cover.
While the Hatch us movable you will have to choose open or closed fore there are 2 supports and they aren’t workable.
Here’s the inside without the gear installed.
I decided to do the hatch open.
I’ll be working on the inside parts next.
I hope this helps , for it has been very confusing for me.
Regards
Donald