Filling seams and sink marks

[18bravo]

That’s always been my go to method:

The M2 OG Bradley

First I had some holes to fill. The front gets the tapered sprue treatment: [image] [image] The rear holes get the same treatment, except for the ones that don’t go all the way through. They get the CA treatment: [image] The new suspension arms look much better - correct angle and length, and have the mounting hardware: [image] The final drives were almost a drop fit. They need a tiny bit of finessing. I recommend filing the hull opening rather than filing on the printed part. Thirty s…

Also shows CA in same post.