Chassis nearly complete… most recent session spent detailing . Clear vinyl tube supplied by Tamiya For crankcase breather looks right from a diameter standpoint. I tinted it yellow with a permanent marker. One line from bottom front of crankcase and one from tower above gearbox go to a catch bottle
( puke tank in common slang) mounted on rear fender . Drain line from bottle dumps by swingarm / final drive chain . This needed a clamp at bottom fashioned from brass shim .
All cables done except for the two for the front brake. These will have to wait until fairing is installed. Tachometer built up and installed- lens made of .005” clear styrene by scribing with needle and circle template, cutting out with scissors and setting in place with Future . 17000 rpm redline warning done with a dot of flat red . Friction damper at headstock and hydraulic damper on right done.
Tank / seat set in place temporarily to check fit - painting up next .
Fairing interior shot with flat black - silver exterior to follow.
Thanks for looking !
Richard