The countdown begins.
One Month to go to kick off.
2 Likes
Still interested for the group built but I’m not sure I will start this one immediately, because I still have a hard resin kit in progress for another group built I have to finish before.
2 Likes
Curious, what kind of 3D printed parts are you adding? I have this kit too which will be built in the next year.
Mike
1 Like
James Lee has created a few parts and I am sure he will include these.
3D prints and CADs Part 2 - by petition2God - #625 by Petition2God?
1 Like
Just over two weeks to kick off. What do you think of this for the badge?
Is the psychedelic ribbon too much?
8 Likes
I was going to add covers to the underside of the fuel tank and battery box, along with a corrected rear floorboards, a corrected steering wheel, gas tank cap and front suspension arms.
this is what the completed kit’s underside looks like; same with the M151A2.
This is what it SHOULD look like (from Vodnik’s website).
7 Likes
Cool badge ! 
3 Likes
I second man. 
2 Likes
Groovy! The ribbon fits “LUVin” perfectly, for those of us old enough to remember!
I think I might do a TOW M151A2.
2 Likes
I am sure there are quite a few of us old enough to remember, Matt. 
It would be great to see you come on board with another M151. The more the merrier.
3 Likes
Some are the byproduct of too much “LUVin”.
4 Likes
@SSGToms Matt, could you please remove this thread from the Staging Area and set it up as an active build. Thank you.
4 Likes
Done.
1 Like
Thanks Matt. You are a Gentleman and a Scholar!.
1 Like
Guys I will be a late starter here, but I look forward to seeing you start your builds though.
2 Likes
Made a start on my ICM Ford LCP today.
Typical ICM. Cleanly moulded and not an insane amount of parts.
Started with the engine and rear cargo bed. No problems to report. A few ejection pin marks on the bottom of the mud guards needed a bit of filler.
6 Likes
A nice little kit by all accounts Stephen. I have it in the stash but keep bumping it. I’m looking forward to see what you do with it.
1 Like
The bed went together really quickly. Just have to watch alignment and keep it all square. The chassis has a few fiddly delicate bits though. But I don’t see any major problems. Have to admit I do have a soft spot for ICM, they do some good stuff and they’re not expensive.
Must do a bit of research into the Middle East campaign in WW1. Short of Gallipoli and Lawrence of Arabia’s antics, I know next to nothing.
1 Like
David Fromkin’s book “A Peace to End All Peace” is an excellent read.
2 Likes
Thanks, I’ll have a look for that.
1 Like